| RAD Data Communications Ltd. |
| Technical Support Department |
| eSupport FAQ Published - December 2006 - January 2007 |
| Issue Date: 22/01/2007 |
| Click the product name to read the answer (Requires your personal eSupport password) |
| Title |
| Product (URL) |
| ID Number |
| 7777 |
| Is it possible to insert four ACE-M/155D modules into one |
| ACE-2002 chassis? |
| 7779 |
| What is the Clock Accuracy of each Stratum Level? |
| 7778 |
| How can I enable the PSN feature and the Clock Recovery feature? |
| 7638 |
| What is the maximum jitter value of the Airmux-200 LAN |
| interface? |
| 7639 |
| What is the minimum and maximum length allowed for the Link |
| Password? |
| 7641 |
| What is the Automatic Adaptive Rate feature? |
| 7783 |
| Do I need to consult with authorities before using an |
| 'unharmonized' radio unit? |
| 7784 |
| What is the Dispersive Fade Margin value for the Airmux-200? |
| 7780 |
| Can I use AMC-101 with a fiber optic module and a coax module |
| to convert Fiber-T3 to Coax-T3? |
| 7645 |
| Is the ASMi-52 modem compatible with 3rd party modem |
| vendors? |
| 7649 |
| What are the ways available to remotely power feed S-RPTs? |
| 7631 |
| From which DXC-100 I/O cards is it possible to determine the |
| line-timing for DXC-100? |
| 7772 |
| Do the DXC family products support E1/T1 Ring Protection |
| topology? |
| 7630 |
| What is the command for clearing a BERT counter in the D8HS |
| module of DXC-30E/30/8R/10A? |
| 7646 |
| Are Egate-100 and Egate-20 compatible with the FCD-IP? |
| 7627 |
| What is the maximum number of VLAN definitions supported by |
| FCD-155? |
| 7629 |
| Is it possible to replace the power supply on site? |
| 7774 |
| Does the FCD-155E support APS protection? |
| 7624 |
| Does FCD-E1M support the HSR/N module? |
| 7773 |
| Is it possible to see the FCD-IPM alarms using RADview? |
| 7637 |
| What V5 byte code will cause the Gmux to issue a Signal Label |
| Mismatch alarm on the VC-12 level? |
| 7642 |
| What are the possible operating modes of the VC-E1/16 / |
| VC-E1/12 Gmux Voice Compression module (VMX)? |
| 7644 |
| How do I manage remote Gmux-2000 inband over TDM link |
| between central and remote Gmux-2000 units? |
| 7643 |
| How do I manage remote Vmux-2100 inband over TDM link |
| between a central Gmux-2000 and a remote Vmux-2100? |
| 7633 |
| Does IPmux-1e/FXS/FXO support Caller ID? |
| 7782 |
| Can ISDN PRA interface traffic be transmitted over the PSN using |
| the IPmux/Gmux? |
| 7632 |
| What is the operating system used in IPmux-11/14? |
| 7781 |
| What is the meaning of the Alarm LED color in the front panel? |
| 7636 |
| Does the IPmux-14 X.21 serial interface support an external |
| clock? |
| 7635 |
| Can the IPmux-14/A enhanced adaptive clock mechanism be used |
| to provide a Stratum-1/2 clock? |
| 7634 |
| Is it possible to configure the destination IP address of a bundle |
| as a DNS name rather than as an IP address? |
| 7625 |
| Does ML-IP work with IPmux-8/16 T1? |
| 7647 |
| How do I configure LA-110 for E1 CES over PSN with MPLS |
| (pseudowire application)? |
| 7648 |
| How do I configure LA-110 for E1 CES over PSN with UDP-IP |
| (pseudowire application)? |
| 7775 |
| Which Megaplex voice modules with an FXS interface can work |
| with 24 VDC power without requiring an external ringer? |
| 7626 |
| Which voice module supports RBF conjunction with E1 links? |
| 7628 |
| Do ML-2E1/V5.2 and ML-1E1/V5.2 support R2 signaling? |
| 7776 |
| Does the maximum temperature of 42°C and the average |
| temperature 35°C influence MTBF or the lifetime of the device? |
| 7650 |
| How are E1s (T1s) mapped in Optimux-1551's STM-1 (OC-3) link? |
| 7742 |
| What steps should I take if the event browser does not show any |
| events? |
| 7785 |
| How do I configure the Vmux VLAN table to pass tagged |
| information in Bridge Mode? |
| 7640 |
| How many sites can be connected using Vmux-310 without the |
| SIP Server? |
| 7786 |
| What information should I send the RAD Tech Support team when |
| I open a Vmux-310 case? |
| 7787 |
| When trying to establish a call across a Cisco gateway, some of |
| the DTMF digits are not passed correctly - is there any parameter |
| 7788 |
| Can Vmux-400 work behind NAT/NAPT? |
| 45 |
| FAQ |
| Grand Total: 45 |
| Page Number: 2 |